Diy rodi refill system.

willtheld

Member
So I've been eyeing the avast barrel tender and finally thought, I could make that myself.


So after some searching I found a 12v pcb that would trigger a relay when one circuit opened and turn it off when another circuit closed.

Easy enough, wire up a couple of float switches add a solenoid and done.

Now my rodi will magically turn on when my 20 gallon trash can is near empty and shut off when full.

Extras I included were a float valve incase the solenoid fails open, and a third float all the way at the bottom below the "low" float to set off an alarm on apex to check the system if it's not filling


Here are a few pictures, id include one of the pcb but it's boxed up in a project box sealed up.

c293e5b7cde479b4a8494d10631dceca.jpg


Here's the solenoid

1acc130535bb23509996752cfd4af07b.jpg


The low float to turn on the rodi and the emergency apex float

6421dce7d77c40b3dac1de332964ab29.jpg


And the inside of it all


Sent from my iPhone using Tapatalk
 
Back
Top