Siebo's 65gal RR Build

Pic of the scoly eating under the moon lights!

269d94a836ea507adcfd08700538d6fc.jpg


164d01f1a5646753eaa440e33000a154.jpg
 
Here is a quick video with the RW-15's on a 3 foot tank. I read a lot of reviews that said these were to much flow on much bigger tanks. I really disagree. Yes I could create a hurricane with them though. These are set on the second to lowest setting on C mode (anti-sync). one pump turns on for about 4 seconds and then off and the other turns on. This is creating a nice wide flow across my 65g tank. no blowing of sand as you can see in the video.

[video=youtube_share;gND-aXAuPuk]http://youtu.be/gND-aXAuPuk[/video]
 
If you put both of them on the same side can you get adequate sps flow across the entire 3' in any setting without blowing sand or blowing water out of the tank? I'm dying to have all my pumps on one side of the tank but the WP10s aren't cutting it for 30".
 
If you put both of them on the same side can you get adequate sps flow across the entire 3' in any setting without blowing sand or blowing water out of the tank? I'm dying to have all my pumps on one side of the tank but the WP10s aren't cutting it for 30".

If I left them in the same mode the are currently it would not blow sand all over.
 
If you put both of them on the same side can you get adequate sps flow across the entire 3' in any setting without blowing sand or blowing water out of the tank? I'm dying to have all my pumps on one side of the tank but the WP10s aren't cutting it for 30".

I just tried this and so far I like it. Video to come.
 
So I hooked up the new dosing pump tonight. Dosing BRS 2 part and mg. Hopefully this will make the numbers more stable! According to calculations I should be dosing 15ml ALK, 12ml of calcium and 15ml of mg. I'll keep testing and see how they change.
 
Last edited:
I have been running biopellets now for about 4 months. I started using a BRS reactor that was a PITA to get to tumble. I just switched it to a modded TF150. The tumble is great.
So, I already had my dual BRS reactor T off of my return. Then I grabbed a few more push connects an T'ed the reactor feed again to feed both my BRS reactor and the TF150 with BP's. I wanted to keep the BRS online incase I need to run carbon or GFO. As you can see the pellet tumble is good now.
https://vimeo.com/109306455
 
Last edited:
Back
Top